Installation: Registered user

Installation step by step:

  1. Before installing the components package, please close all Delphi and C++ Builder IDEs.

    Note, for each IDE, if it's a clean installation, please run it at least once before installing the components package, then closes it and continues installation.

  2. Please uninstall the trial release using the "Uninstall" shortcuts in the "Start Menu" if it is installed in your computer.
  3. Please download the installation package using the download link that's sent from us after you purchase the components package. If your download link doesn't work, please request a new download link, the user name and the email address the purchase was made with are required.
  4. Run the installation file barcode2d_ful.exe, and then click on the "Next" button in the installation dialog box.
  5. Read the End-User License Agreement. You must accept the terms of this agreement before continuing with the installation. And then click on the "Next" button.
  6. Type your email address and the license key that they are sent from us after you purchase the components package, they are not case-sensitive. And then click on the "Next" button. If you forgot the license key, please retrieve it, the user name and the email address the purchase was made with are required.
  7. Specify a target folder (it will be created if does not exist), the components package will be installed into it. And then click on the "Next" button.
  8. All supported Delphi and C++ Builder IDEs will be listed automatically according on the existing IDEs in your computer. Please select the IDEs you want to install to them. And then click on the "Next" button.

    Note, The Delphi 4, 5, 6, 7, 2005, 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4 and C++ Builder 4, 5, 6, 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4 are supported now. The Delphi 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4 and C++ Builder 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4 are listed as RAD Studio (Delphi & C++ Builder) 2006, 2007, 2009, 2010, XE, XE2, XE3, XE4.

  9. Specify a shortcuts folder in "Start Menu" for the components package. And then click on the "Next" button. Later, you can open the manual or remove the components package in the shortcuts folder.
  10. Click on the "Install" button to complete the components package installation.
  11. Click on the "Finish" button to close the installation dialog box.
  12. You can start your IDE to use the components package now.

Note:

Contents